How to Put a Net on a Basketball Hoop – Learn with Tips!

Does your basketball net wear out after using it for a couple of years? Are you getting tense about how to put a net on a basketball hoop? Even if it isn’t worn out, it may begin to seem dingy and dirty. However, you may wish to change your basketball net by switching to a different style, color, or net type.

Give a read to this article carefully to learn with easy tips by following the below stated steps. 

Necessary resources:

  • A new basketball net.
  • A helper.
  • A pair of scissors.
  • A step ladder.
How to Put a Net on a Basketball Hoop

How to put a net on a basketball hoop – Learn with tips by following eight easy steps:

The directions for putting up a basketball net are as follows. This set of instructions is for a conventional basketball rim and net.

Step-1: Adjust the ladder.

If you don’t have an adjustable hoop, you will need a ladder to put a net on your basketball hoop. Set the ladder right under the front of the basketball rim.

Step-2: Climb the ladder.

Climb the ladder with caution after adjusting it to cut the old net.

Step-3: Remove the old net.

Ask your helper to hand the scissors after you get stable on the ladder. Then cut the loops right next to the rim and remove the old net from the hooks.

Step-4: Determine the exact net side.

Now find the same net side to adjust to the rim. The longer loop’s end side will be the one you use to secure the rim.

Step-5: Push the loop through the rim hook.

Grab a long net loop to squeeze it so that you may push it from the inside of the rim to the outside of the rim through the rim hook.

Step-6: Install the net loop.

Allow enough room in the net loop to loop it around the rim hook’s front. Then, pull the net loop firmly to fasten it in the rim hook.

Step-7: Connect the remaining net loops to the hooks.

Steps 5 and 6 should be repeated for the remaining net loops and rim hooks. Again, make sure the net loops stay straight and don’t mix up with the other loops.

Step-8: Tight the net.

Now grab the net bottom and pull it down forcefully to verify that all of the loops are connected.

FAQS:

How can I put a net on my basketball hoop without a hook?

Answer:

You can put a net on your basketball hoop without a hook by following methods. These are:  

  1. The Tape Method
  2. The Knot Method
  3. Rope & Loop Method 
  4. Cut & Tie Method and
  5. Chain Net 

How can I attach a basketball hoop to the wall?

Answer:

Take a Basketball hoop anchor and drill it on the wall and then screw it for stability. Next, put your basketball hoop on top of it to drill out the screw through the basketball hoop.

Why do basketball players prefer double rims for practice?

Answer:

The basketball has a greater probability of bouncing out on a double-rimmed hoop than on a standard hoop. Players prefer double rims for practice because it forces them to shoot more accurately.

Conclusion:

A careful read on how to put a net on a basketball hoop will enable you to replace the old net to try a new color or style on your basketball rim. The replacement of a basketball hoop net is pretty simple, so enjoy the new look and play.

Read More Article

1 thought on “How to Put a Net on a Basketball Hoop – Learn with Tips!”

Leave a Comment

Your email address will not be published. Required fields are marked *

Show Buttons
Hide Buttons